Perancangan Dan Realisasi Prototype Sistem Transfer Daya Listrik Nirkabel Untuk Mengisi Baterai Handphone
Main Article Content
Keywords
Abstract
Ongoing trends in standardized mobile phone charger is charging process with user-friendly wireless power transfer that eliminates the cable connection between the charger and the phone. Wireless power transfer provides convenience in mobile phone battery charging, do not have to hassle with wires and plugs, simply put the phone on the pad. The research design and realize a prototype of a wireless power transfer system for charging mobile phone batteries. This research used high frequency transformer 12 V 25 kHz, the primary coil (20 turns, diameter 9 cm), the secondary coil (36 turns, diameter 9 cm), rectifier and filter and regulator. The result showed that the device and the circuit is designed to perform charging mobile phone batteries with maximum distance required to produce a voltage of 5 volts at the input terminal of mobile phone batteries is as far as 2 cm. In addition, the time required to perform a full battery charge until the phone is 60 minutes with constant charging rate.
Keywords: magnetic Induction, Resonance, Electromagnetic, Wireless power transfer
Abstrak
Tren yang sedang berlangsung dalam standarisasi charger handphone adalah proses pengisian user-friendly dengan transfer daya nirkabel yaitu menghilangkan sambungan kabel antara charger dan handphone. Transfer daya nirkabel memberikan kemudahan dalam pengisian baterai handphone, tidak perlu repot dengan kabel dan colokan, cukup meletakkan handphone pada bantalan. Penelitian ini merancang dan merealisasikan sebuah prototype sistem transfer daya nirkabel untuk pengisian batere handphone. Dalam penelitian ini digunakan high frequency transformator 12 V 25 kHz, primary coil (20 lilitan, diameter 9 cm), secondary coil (36 lilitan, diameter 9 cm), rectifier and filter dan regulator. Dari hasil penelitian diperoleh bahwa alat dan rangkaian yang dirancang dapat melakukan pengisian batere handphone dengan jarak maksimum yang dibutuhkan untuk menghasilkan tegangan 5 Volt pada terminal masukan batere handphone adalah sejauh 2 cm. Selain itu, waktu yang diperlukan untuk melakukan pengisian batere handphone hingga penuh adalah 60 menit dengan laju pengisian konstan.
Keywords: magnetic Induction, Resonance, Electromagnetic, Wireless power transfer
References
[2] ----------. EMPro 3D EM Simulation Software. diunduh Mei 2013 dari http://www.home.agilent.com/en/pc-1297143/empro-3d-em-simulation-software
Article Sidebar
Article Details
Authors who publish with this journal agree to the following terms:
- Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
- Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
- Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (See The Effect of Open Access).
The authors declare that:
1. This paper has not been published in the same form elsewhere.
2. It will not be submitted anywhere else for publication prior to acceptance/rejection by this Journal.
3. A copyright permission is obtained for materials published elsewhere and which require this permission for reproduction.
Sherly Puspita Rahman, Fakultas Elektro dan Komunikasi Institut Teknologi Telkom
Fakultas Elektro dan KomunikasiInstitut Teknologi Telkom
Mas Sarwoko, Fakultas Elektro dan Komunikasi Institut Teknologi Telkom
Fakultas Elektro dan KomunikasiInstitut Teknologi Telkom
Zulfi ., Fakultas Elektro dan Komunikasi Institut Teknologi Telkom
Fakultas Elektro dan KomunikasiInstitut Teknologi Telkom