Feasibility Study Designing Electric Motorcycles With Fossil Fuels Compared To Hybrid Systems On 150Cc Motorcycles

Pawenary Pawenary, Septianissa Azzahra, Hastuti Azis, Anton Satria Prabuwono

Abstract


In this study, an electric vehicle was designed using fossil fuels compared to the hybrid system on a 150cc motorcycle. The design of electric motorcycle vehicles is focused to know the feasibility study comparison between engine drive and electrical drive. In the design of electric motorcycle vehicles know how to make technical economic calculations on electric motorcycles. And converting energy from mechanical energy into electric energy or vice versa requires a device called an electric motor. Having the knowledge and experience in the manufacture of electric motors will be more useful and become important in the future. Electric vehicles are the solution to the problem of depleting petroleum reserves and pollution problems that increase each year due to exhaust emissions produced by oil-fueled vehicles. contribution of motor vehicle exhaust as a source of air  pollutionreaches  60-70%. The decline of fossil fuels in the world is also a major problem that is currently unresolved. The analytical technique used in this study is a descriptive statistic technique. Where in this study will be carried out an assessment of the technical data that occurs on the calculation of the speed of what motor is in accordance with the specified  standards.


Full Text:

PDF

References


"COMPARATIVE ANALYSIS OF EXTRINSIC AND INSTRINSIC MOTIVATION BETWEEN GOJEK DRIVER AND GRAB DRIVER IN MANADO," J. EMBA J. RIS. Ekon. Management, Business and Accounting. , vol. 6, no. 4, 2018, doi: 10.35794/emba.v6i4.21058.

K. Biomantara and H. Herdiansyah, "The Role of Indonesian Railways (KAI) as Urban Area Transportation Infrastructure," J. Hum. Bina Sarana Inform. Horizon, vol. 19, no. 1, 2019.

A. A. Purwati and M. L. Hamzah, "Total service quality management and it's impact on customer satisfaction and loyalty of online transportation in Indonesia," Int. J. Sci. Technol. Res. , vol. 8, no. 11, 2019.

L. A. P.F. De Brito, J.B. Carvalho, and V. D. Toledo, "The efficiency of mathematical algorithms for urban noise evaluation," Urbe, vol. 10, no. 1, 2018, doi: 10.1590/2175-3369.010.001.AO03ISSN2175-3369.

M. Razban and H. I. Talab, "Designing bandar abbas railway station by sustainable architecture approach (Climatic sustainability)," IIOAB J. , vol. 7, 2016.

H. Chang, Y. Wang, Z. Li, B. Lin, Z. Song, and J. Tan, "Regional ecological risk assessment based on nitrogen export: A case study in Chinese Taiwan," Shengtai Xuebao/ Acta Ecol. Sin. , vol. 36, no. 4, 2016, doi: 10.5846/stxb201406031144.

M. Panayotova, "The motor vehicles - A significant cause for air pollution in the big towns of Bulgaria," J. Environ. Sci. Heal. - Part A Toxic/Hazardous Subst. Environ. Eng. , vol. 31, no. 1, 1996, doi: 10.1080/10934529609376349.

P. Podesser, "Unlimited cruising range - How fuel cells empower electric vehicles," in Electric Drive Transportation Association - 23rd Int. Electric Vehicle Symposium and Exposition 2007, EVS 2007 (Battery, Hybrid, Fuel Cell) Conf. Proc. - Sustainability: The Future of Transportation,2007, vol. 2.

M. Latif, A. Valdesio, and M. Muharam, "Electrical Energy from Motorcycle Regenerative Braking using Bicycle Dynamo," J. Nas. Tech. ELEKTRO, vol. 7, no. 2, 2018, doi: 10.25077/jnte.v7n2.503.2018.

G. Jungmeier, The Biorefinery Fact Sheet,vol. 23, no. 1. 2017.

S. S.M, G. S. Tantri, M.M. J, V. Ch, G. G. L, and V. kumar G. Naik, "Intelligent Solar Tracker Vehicle for Supply Channel of Electric Vehicle Need Using Image Processing and Mobile Network," Int. J. Innov. Sci. Res. Technol. , vol. 5, no. 6, 2020, doi: 10.38124/ijisrt20jun1126.

F. Maulana, "ECO-FRIENDLY THREE-WHEELED ELECTRIC VEHICLE DESIGN CONCEPT," Maj. Ilm. Pengkaj. Ind. , vol. 10, no. 2, 2018, doi: 10.29122/mipi.v10i2.141.

Y. Park, H. Kim, H. Jang, S. H. Ham, J. Lee, and D. H. Jung, "Efficiency Improvement of Permanent Magnet BLDC with Halbach Magnet Array for Drone," IEEE Trans. Appl. Supercond. , vol. 30, no. 4, 2020, doi: 10.1109/TASC.2020.2971672.

D. S. Nayak and R. Shivarudraswamy, "Solar fed BLDC motor drive for mixer grinder using a boost converter," Int. A. Power Electron. Syst Drive. , vol. 11, no. 1, 2020, doi: 10.11591/ijpeds.v11.i1.pp56-63.

M. Mahmud, S.M. A. Motakabber, A. H.M. Z. Alam, and A. N. Nordin, "Control BLDC motor speed using PID controller," Int. A. Adv. Comput. Sci. Appl. , vol. 11, no. 3, 2020, doi: 10.14569/ijacsa.2020.0110359.

D. Potnuru, K. Alice Mary, and C. Sai Babu, "Experimental implementation of Flower Pollination Algorithm for speed controller of a BLDC motor," Ain Shams Engineering Journal, vol. 10, no. 2. 2019, doi: 10.1016/j.asej.2018.07.005.

K. Kolano, "Improved sensor control method for BLDC motors," IEEE Access, vol. 7, 2019, doi: 10.1109/ACCESS.2019.2960580.

M. S. Trivedi and R. K. Keshri, "Evaluation of Predictive Current Control Techniques for PM BLDC Motor in Stationary Plane," IEEE Access, vol. 8, 2020, doi: 10.1109/ACCESS.2020.2978695.

D. Kumpanya, S. Thaiparnat, and D. Puangdownreong, "Parameter Identification of BLDC Motor Model Via Metaheuristic Optimization Techniques," Procedia Manuf. , vol. 4, 2015, doi: 10.1016/j.promfg.2015.11.047.




DOI: https://doi.org/10.25077/jnte.v10n2.906.2021

Refbacks

  • There are currently no refbacks.


  

       


 Statistic and Traffic